RCT Portal Web design Internet solutions linux - Programming Microsoft MCE Remote Control

Anonymous writes "sing the MCE Remote Control Learning Functionality:

The TV, Vol+ and Vol- buttons on the remote control can "learn" IR commands from other remote controls. This feature lets you use the TV button to turn on your TV and the Vol+ and Vol- buttons to adjust the volume on your TV or another device such as an audio receiver.

By default the Vol+ and Vol- buttons on the remote your pc sysyem volume and the TV button has no command assigned until it "learns" one.

Do not perform this procedure in bright or natural light.

1. Place the remote head-to-head (2-3" apart) with the remote control from which it is learning

2. On the MCE remote press and hold the DVD MENU and OK buttons at the same time until the LED turns off. (~2 sec)

The remote is now in learning mode.

3. On the MCE remote, press and release the TV, Vol+ and Vol-, depending on which command you want it to learn.

The MCE remote blinks once to confirm the selection.

4. On the remote control that is teaching the command, press and hold the button that you want the corresponding button on the MCE remote to learn.

The MCE remote LED flashes twice to confirm the selection

If the remote did not learn the command, the LED blinks quickly four times.

To try again, repeat steps 1 through 4.

---------

To restore the default remote control settings

1. Press and hold the DVD MENU button and the LEFT navigation button at the same time until the MCE remote LED turns off.

2. Press the OK button.

The MCE remote LED blinks twice to confirm that the buttons have been reset.

The TV button will have no command assigned to it and the Vol+ and Vol- will adjust the MCE system volume.

If the default settings were not restored, the LED will blink quickly four times. To try again, repeat steps 1 and 2."